EngA Engineered Air XES-SC Series

Questions and Answers:

J
John OsbornAug 11, 2025
How to fix EngA Heat Pump not enough heat?
- M
  Mark RodriguezAug 11, 2025
  If your EngA Heat Pump isn't producing enough heat, it could be due to a few reasons. The mixing damper operator might not be working correctly; in this case, adjust the mixed air to a warmer setting, check the dampers, and adjust them if needed, or replace the damper operator. Another cause could be low gas pressure, which requires adjusting or replacing the regulator. Lastly, the furnace might be short cycling on limit switches, which can be resolved by tightening or replacing the blower belt, checking the I.D. fan and switch, and cleaning or replacing the filters.
B
bvasquezAug 20, 2025
What to do if I see flame roll out in my EngA Heat Pump?
- M
  Mark GarciaAug 20, 2025
  If you're experiencing flame roll out or notice a flame in the manifold compartment of your EngA Heat Pump, several factors could be responsible. A blocked flue or chimney could be the cause, so ensure the vent or chimney is free of obstructions. Insufficient combustion air might also be the problem, so try to increase the combustion air supply. Other potential issues include a leaking gas solenoid valve, which would necessitate replacing the gas valve; high gas pressure, requiring a reset or replacement of the regulator; or a blocked or damaged intake screen, which should be repaired or cleaned.
W
William SanchezAug 31, 2025
Why EngA Heat Pump has no heat?
- R
  Randall WilsonSep 1, 2025
  If your EngA Heat Pump isn't producing any heat, there are a few things you can check. First, a blown control module fuse could be the culprit. Check for the cause of the blown fuse and then replace the fuse or the S825 Module. Another possibility is that the ventor motor air proving switch isn't working, in which case you should repair or replace the air proving switch. Finally, there might be no gas supply reaching the manifold, so check the main gas supply.