ENGEL dealer if there are any questions regarding engine generators and the product
compatibilities.
OPERATON
To operate the product – insert the cigarette lighter plug of the DC cord into the cigarette lighter
socket of the vehicle.
The product will start operating once the power supply is ON
TEMPERATURE SETTING (see Fig 6)
Temperature range – Achievable temperature from
-18 ～ 55℃ ( 0 ～ 131°F ) at Ambient of 25°C
(77°F).
The preset temperature is displayed when the LED
starts blinking.
The approximate interior temperature of the cabinet
will be displayed once the LED lights up.
When the “SET” button is depressed for 3 seconds
(long push), the LED display will blink.
During this mode, the cabinet temperature can be
selected by pressing the “UP” and ”DOWN” button.
Pressing/holding onto the “UP” and ”DOWN”
buttons will continuously change the range of the
temperature.
After pre-setting the temperature, the LED display will stop blinking (after a few seconds), indicating
the temperature has been set (lock).
It is not necessary to reset the temperature again as the temperature has been stored.
The product will now operate at the selected temperature.
− 5 −
It is possible to select between Celsius or Fahrenheit with product.
When the “SET” button is depressed for 3 seconds, the LED display will blink. Pressing
the “SET” button during this mode will display the °C →°F →°C →°F change.
After pre-setting the temperature, the LED display will stop blinking (after a few seconds),
indicating the temperature has been set (lock).
=CAUTION=
Control button, LED display and other Electrical products are no toys.
Please keep and use the product out of the reach of children.
TROUBLESHOOTING
Error message will be displayed if the voltage of the battery is low or in the event of
any malfunctions – (see table below).
When error message is displayed, the unit will be on “standby mode”. Operations will stop.
SELECTING TEMPERATURES (°C or °F).
To Next Page
Loading...
Need help?
General
