EP800 Quick Installation Guide English
Base Station Installation
1.
Install base station antenna.
2.
Plug the transformer end of the base station AC/DC adaptor into a
standard AC electrical power outlet, plug the other end into the “DC In”
jack on the back of the base station.
3.
Plug phone cord into the “LINE” Jack.
4.
A standard telephone or answering machine can be plugged into the
adjacent receptacle on the bottom of the base station marked TEL.
Handset and Charger Installation (Charger only for EP800H)
1.
Plug the transformer end of the Charger AC/DC adaptor into a
standard AC electric power outlet, plug the other end into the “DC In”
jack on the back of the Charger.
2.
Install battery pack onto the handset.
3.
Install handset antenna.
4.
Place handset onto the charger front slot.
5.
Fully charge the battery for three hours before use.
6.
The phone system is now ready to perform basic functions such as
making and receiving phone calls and
intercom calls. No base station
or handset programming is needed for basic operations.
Press MENU-7 to enter the registration mode
2.
Press and hold the base’s PAGE button for 3 seconds until the In Use LED (white color) lighting up and
flashing, also the base station will emit prompt sound to remind you the base station is in the registration
mode.
3.
Press handset key “1”, this completes the registration process. The base station will assign a handset
ID between 12 and 19 automatically. The assigned ID will be displayed on the handset LCD, indicating
successful registration.
Handset features
1.
Places or answers a telephone or intercom call
b.
Sends a Flash signal to phone line to retrieve a dial tone after the call
ends, or to perform the call waiting feature provided by local phone
companies during a call.
2.
SPEAKERPHONE ( )
Press and hold the key for over 2 second to enable/disable the
speakerphone during incoming, outgoing or intercom call.
To Next Page
Need help?
General
