EnGenius EP800 User Manual

DocNo.FM0805issueAPage1
Adventxt
WardenCallSystem


______________________________________________________________________________________________________________





OperatorsGuide
ENGENIUSEP800CORDLESSTELEPHONE

Tynetecoperatesapolicyofcontinualproductimprovementand
reservestherighttomodifythespecificationofitsproducts.

Ifanyvariationtothedetailsinthisdocumentaresuspectedplease
contactTynetec’sTechnicalSupporton01670352371.







Tynetec,abusinessunitofLegrandElectricLtd
Unit10CowleyRoad,BlythRiversideBusinessPark,Blyth
Northumberland,NE245TF.Tel:01670352371Fax:01670362807
Email:sales@tynetec.co.ukWeb:www.tynetec.co.uk

EnGenius EP800 Specifications

General

Type	Cordless Telephone
Frequency	900 MHz
Number of Lines	1
Display	Backlit LCD
Headset Jack	Yes
Range	Up to 3, 000 acres (outdoor)
Battery Life	50 hours standby
Features	Intercom
Number of Handsets	Up to 9

Summary

Standard Intercom Unit Features

Privacy Button Operation

Controls privacy on/off, toggles away mode.

I'm OK Button Functionality

Allows resident to signal they are OK, stopping alerts.

Alarm Button and Pullcord Use

Initiates emergency calls and overrides privacy mode.

Combined Intercom Unit Functions

Door Open Button Use

Releases door locks for visitor access.

Cordless and Desktop Telephone Features

Calling a Resident Procedure

Step-by-step guide to contacting residents via phone.

Fire Alarm Functionality

Manual Fire Tone Activation

How to manually trigger the fire alarm tone.

Automatic Fire Call Response

How to respond to automatic fire alarms.

Selecting the Operating Mode

Mode Selection via Cordless Handset

Changing operating mode using special phone codes.

Mode Selection via Manager's Panel

Changing operating mode using a control panel.

Fault Memory Management

List the Fault Memory

View stored system faults and their status.

Clear a Fault from Memory

Remove specific faults after rectification.

System Time and Date Settings

Setting the System Time

Configures the system's real-time clock.

Setting the System Date

Local Offsite Mode Operations

Answering a Local Offsite Call

Local Offsite Mode Enable/Disable

Releasing Main Entrance Door Lock

Extracare Functionality

Cancelling an Extracare Call

Procedure to locally cancel an Extracare alarm.

Global Activity Monitoring

Setting Global Activity Start Time

Setting Global Activity Stop Time

Global Activity Monitoring Control

Disable Vacant Flats Monitoring

Local Activity Monitoring Setup

Setting Local Activity Start Time

Setting Local Activity Stop Time

Intruder Functionality

Set Intruder Mode

Client Wandering Function

Setting Wandering Start Time

Setting Wandering Stop Time

I'm OK Function Configuration

Setting I'm OK Start Time

Configures the start time for the 'I'm OK' check.

Setting I'm OK Stop Time

Configures the stop time for the 'I'm OK' check.

Enable I'm OK for All Flats

Away Mode Functionality

Radio Trigger Management

Adding a Radio Trigger

Allocating a Telecare radio device to a flat.

Removing a Radio Trigger

Deleting All Radio Triggers

Message Service Usage

Recording a Message

Telephone Privacy and Fault Checks

List Telephones in Privacy Mode

Data Back-up and Restore Functions

System Data Back-up

Saves system configuration data to memory.

System Data Restore

Restores system configuration from memory.

Radio Device Data Back-up

Saves radio device data to memory.

Zoned Network Receiver Signal Strength

Attenuate Receiver Signal Strength

Reduces signal strength to improve zone accuracy.

Intercom Unit Test Mode

Enter Test Mode

Puts an intercom into test mode for device checking.

End Test Mode