EnGenius EP800 - Client Wandering Function; Setting Wandering Start Time; Setting Wandering Stop Time

DocNo.FM0805issueAPage22
28.USINGTHECLIENTWANDERINGFUNCTION

TheAdventxtsystemcanbeusedwitharadiodoorcontact(TynetecP/No.ZXT434)tomonitor
ifaresidentleavestheirflatduringapresettimeperiodeachday.

Thestartandstoptimescanbesetonanindividualflatbasis.

Ifaresidentleavestheirflatduringthesetperioda“clientwandering”alarmwillbereported.

SETTINGTHEWANDERINGSTARTTIME:

1.PresstheTALKkeyandenter81
2.Waitforthe“Ready”promptintheearpiece
3.Enterthecode6000followedbythekey
4.Entertheflatnumberfollowedbythekey
5.Amessagewillannouncethecurrentstarttime
6.IfthesettingisOK,presstheENDkey
orenteranewstarttime(HHMM‐24hourformat)or,pressthe#keytodisablethetimeperiod
7.Pressthekeytoconfirmanda messagewillannouncethenewstarttime
8.PresstheENDkeytocleartheconnection
______________________________________________________________________________________________________________

SETTINGTHEWANDERINGSTOPTIME:

1.PresstheTALKkeyandenter81
2.Waitforthe“Ready”promptintheearpiece
3.Enterthecode6001followedbythekey
4.Entertheflatnumberfollowedbythekey
5.Amessagewillannouncethecurrentstoptime
6.IfthesettingisOK,presstheENDkeyorenteranewstoptime(HHMM‐24hourformat)
7.Pressthekeytoconfirmanda messagewillannouncethenewstoptime
8.PresstheENDkeytocleartheconnection
______________________________________________________________________________________________________________

WANDERINGENABLEDREPORT:

1.PresstheTALKkeyandenter81
2.Waitforthe“Ready”promptintheearpiece
3.Enterthecode6002followedbythekey
4.AllflatswithClientWanderingenabledwillbeheardintheearpiece
5.PresstheENDkeytocleartheconnection
______________________________________________________________________________________________________________




















Whensettingtimes4digitsmustbeenteredusingthe24hourformatwithleadingzerosfornumbers
lessthan10(eg.0730=7:30AM,1600=4:00PM).

Clientwanderingtimeperiodscanbesettoanyduration(lessthan24hours)andthestart/stoptimes
canbeovernightspanning2differentdays.

Ifthe#keyisusedtodisableatimeperiodthiswillnotcleartheoriginalsetting.Tore‐enabletheoriginal
settingsimplyentertherelevantcode,listentothemessageandpresstheENDkey.


START
STOP