EnGenius EP800 - Intercom Unit Test Mode; Enter Test Mode; End Test Mode

DocNo.FM0805issueAPage33
41.INTERCOMUNITTESTMODE

Theintercomunit“TestMode”allowsallceilingpullcords,smoke detectorsandradiopendantsetc.tobetestedonaper‐flatbasis
withoutputtingacallonthesystem.OnceinTestModetheintercomwillbeepaseachdeviceisactivated,thesystemprinterwilllog
eachtest
withtheflatnumber,devicetype,time&date.

TheintercommustbeinaquiescentstatetoentertheTestMode,i.e.notinprivacymode,notinawaymode,nomessagewaiting,no
alarmcallinprogressandnotawaitingExtracarecancellation.























______________________________________________________________________________________________________________

ENTERTESTMODE:

1.Pressandholdthekeyforapprox5seconds untiltheintercombeepsonce‐thenreleasewithin2seconds.
2.TheintercomlightwillilluminateSTEADY WHITEanda7toneascendingscalewillplayonce.
3.Radiodevices(eg.personalpendants)mustbetestedfirst‐onceanyhardwiredceilingpullcordsorsmokedetectorsareactivatedno
furtherradiodeviceswillberecognised.
4.Theintercomwillbeeptwiceaseachdeviceisactivated.
______________________________________________________________________________________________________________

ENDTESTMODE:

1.TestModecanbeendedatanytimebypressingthekeyonce
2.Theintercomwillplay4descendingtonesandthe
STEADY WHITElightwillgoout.
3.Asafail‐safetheTestModewillendautomaticallyafter10minutes.
______________________________________________________________________________________________________________














Hardwiredmovementdetectors(PIR’s)areonlyreportedevery30seconds,thisistoallowmovementthroughthe
dwellingtogettothenextdevicewithoutre‐triggeringthePIRontheway.

Whenanyceilingpullcordisactivatedallpullcordreassurancelightswillbeilluminatedfor2seconds.

OnlyoneintercomcanbeinTestModeatanygiventime.

TestModecannotbeenteredviaaremoteintercom.



1.Pressandholdthe

key
forapprox5secondsuntil
theintercombeepsonce
thenrelease…
3.Thelightwillbe

STEADY WHITE
w
henTestModeisenabled
2.Sevenascendingtones
willsoundand…
Imageshowsastandard
intercom…
thesametestmodecan
beenteredona
combinedintercom.