29
Nozzle retracts only when button is pressed after cleaning is done.
5. Rotate the stainless steel part of the nozzle body
counterclockwise and separate it so that it may be
cleaned with a sponge, etc.
6. To put the stainless steel part back onto the nozzle body,
rotate the stainless steel part clockwise with the hole
facing downwards.
7. Put the cleaned nozzle tip back onto the nozzle body
while holding the nozzle body.
Press button on the main unit control panel.
5
Put the nozzle cleaning cover back and slowly close the toilet seat
and cover.
6
Make sure the stainless steel part is secure.
Note
Do not damage the nozzle hole.
Do not apply excessive force to the nozzle.
Do not separate and clean the nozzle too often. Doing so may cause a problem.
Cleansing nozzle tip is assembled a little tightly to ensure air-tightness.
Be careful so that no bodily injury may occur when separating the nozzle tip for cleaning.
Note
Putting back the cleaned nozzle tip onto the nozzle body without
holding the nozzle body may let the nozzle go into the product,
so this may lead to product breakdown or failure.
Note
To Next Page
Loading...