33
Actions to be taken during power disruption
If the power plug is disconnected and connected again, or after power disruption, the main unit
settings are reset, thus resulting in different settings between remote control and main unit.
In such case take the following actions:
.
Check if power plug was disconnected and
connected again or there has been power
disruption.
. On the remote control, set the
automatic seat cover operation and
cancel it.
The product is not in automatic
seat cover operation mode, but
it operates as it is in automatic
mode.
. Check if power plug was disconnected and
connected again or there has been power
disruption.
. Press seat temperature control button
(high or low) one or two times and then
reset the seat temperature.
Toilet seat is cold or not warm
enough.
. Check if power plug was disconnected and
connected again or there has been power
disruption.
. On the remote control, set the
deodorisation and cancel it.
Deodorisation is set to “OFF”,
but main unit deodorisation
lamp is “ON” and deodorisation
operates when the seat is occupied.
. Check if power plug was disconnected and
connected again or there has been power
disruption.
. Press power saving button to set it “OFF”
and reset the desired power saving mode
(LO or HI Econo)
Power saving (LO or HI Econo) has
been set, but power saving lamp on
the main unit is “OFF” and power
saving is not operating.
Action to be takenStatus Cause
To Next Page
Loading...