Need help?Do you have a question about the Engler Vet II and is the answer not in the manual?
Crucial instructions and warnings to be read carefully before use.
Guidance on connecting the unit to a water source.
Important reminder about disconnecting the device when not in operation.
Instructions for connecting the device to a power outlet.
Procedure for inserting and changing scaler tips.
Warning against leaving vibrating tip in one spot, causing damage.
Caution on excessive pressure causing enamel damage.
Warning that contact with soft tissue causes burns.
Daily maintenance tasks for the scaler unit.
Instructions for cleaning and sterilizing scaler tips.
Cleaning and sterilization procedures for handpiece and cables.
Important safety precautions for using the polisher.
Prophy angle speed rating and precautions.
Recommended lubrication methods for the straight handpiece.
Procedures for cleaning and sterilizing the handpiece.
Crucial warnings regarding micromotor operation and maintenance.
Troubleshooting steps for when the ON LED indicator is off.
Troubleshooting steps for lack of water flow.
Steps to resolve hot water issue from the handpiece.
Troubleshooting for intermittent tip operation.
Troubleshooting steps for when the polisher's ON LED is off.
Troubleshooting steps for a hot straight handpiece.
Troubleshooting steps for a hot micromotor.
Troubleshooting for intermittent polisher operation.
Daily procedures for cleaning and lubricating the prophy angle.
Details on connecting the saddle valve to water sources.
Steps to pierce the copper tube with the saddle valve for water flow.
Step-by-step instructions for filling and pressurizing the water tank.
Troubleshooting common problems with the water tank.
Important warnings and safety precautions for water tank use.
Specific care and maintenance to prevent slime and damage.
Procedures for sterilization of maintenance-free prophy angles.
Steps to take after each prophy procedure.
Important cautions and warnings for prophy angle use.
Conditions under which the prophy angle warranty is void.
Technical specifications for the scaler unit.
Water input pressure requirements.
Technical specifications for the polisher component.
Technical specifications for the micromotor.
Technical specifications for the straight handpiece.
Technical specifications for the prophy angle.
Net weight of the scaler unit.
Physical dimensions of the scaler chassis.
Length specifications for various cables.
Net and shipping weight of the unit.
General| Model | Vet II |
|---|---|
| Current | 7 mA |
| Focal Spot Size | 0.8 mm |
| Anode Material | Tungsten |
| Category | Dental |
| Manufacturer | Engler |
| Type | Dental X-ray unit |
| Cooling System | Oil-cooled |
| Weight | 60 lbs (27.2 kg) |
To Next Page
