FCC CAUTION
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
ThisThis device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause interference damage, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
IMPORTANT NOTE:
ThisThis equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules: designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
teltelevision reception, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
STORAGE
1. Protect the product from humidity, animals / parasites, dirt.
22. Store the product in a safe and well-ventilated place, avoid exposure to intense
sunlight and corrosive gases and liquids after use. Do not place heavy objects on
the product to prevent it from deforming.
3. W hen a fault occurs, contact a qualified service for repair. The product contains no
user serviceable parts.
4. Before cleaning the product, be sure to turn off the power. For cleaning, use a soft,
dry sponge or cloth. Avoid getting the product wet , so as not to damage it.
5. Do 5. Do not immerse the product in any cleaning liquid.
6. Do not use abrasive cleaners to prevent the surface of the product from becoming
discolored. Corrosion can cause the product to break.
7. Do not use this product for any purpose other than those described in this
instruction manual.
8. Do not expose the product to direct sun light, to avoid discoloration of the surface.
99. Check the product frequently. In case of signs of wear or damage, or if the product
has been used improperly, the product must be checked by qualified personnel
before being used again.
PROTECTION OF HEALTH AND THE ENVIRONMENT:
Product packaging can not be thrown or burned, it should be sent for
waste recycling. Observe the regulations regarding the collection and
recycling of waste in your municipality.
AAt the end of its useful life, the product must not be thrown away as
common waste, it must not be disassembled or burned. Discard the
product in accordance with the waste disposal regulations of your
municipality.
8
To Next Page
Loading...