Doc.-ID: COMGAS_11022020_EN
Preface
Dear Customer,
Thank you for selecting COMTEC
®
6000 GasEx as your InSitu Flue Gas O
2
/ COe Analyzer System.
Since 1980 our analyzer systems have been operating in numerous applications with tens of thousands of units being produced
and shipped worldwide. ENOTEC is committed to absolute quality and performance and over time we have continuously
enhanced our products to integrate various features and functions.
In this package, the electronic unit uses the very latest Microprocessor Technology, making the SME5 electronic unit one of the
most advanced and up-to-date monitoring units, permitting you to reduce your maintenance & fuel costs and to achieve
increased measuring accuracy with operational reliability.
ENOTEC probes include the zirconium oxide sensor which has a gas-tight seal made by using a special process and technique
developed by ENOTEC. This leads to a considerably increased service life compared to "glued or cemented" sensors that have
a tendency to leak or crack during operation.
All ENOTEC instruments are thoroughly tested in the factory and are subject to a strict ISO 9001 and internal quality assurance
procedure. Therefore, with correct installation, the operation of the COMTEC
®
6000 GasEx InSitu analyzer system is
straightforward and user friendly and will provide you with many years of trouble free operation with perfect measuring results.
Symbols used in this Manual
All symbols listed beneath, attached to the analyzer or noted in this manual show important information as well as safety
instructions for installation, operation and maintenance, to protect the personnel and the equipment.
Warning
Follow all instructions in this manual
Consider Following Information
Points out important information which must be
noted before execution
Warning hot Surface
Warns of danger of burns which could occur from
hot system parts
Info
Contains further detailed information
Caution
Warns of risks by destroying the system or its
components or its functionality
Ground earth electrical protection
The content of this manual is protected by copyright. Alterations and errors reserved.
Safety Instruction
This system is operated with line voltage. If covers are removed during which line voltage is still connected, an electric shock
hazard will occur.
Only well trained and authorized personnel are allowed to conduct work on this system. Personnel have to understand all
precautions, safety instructions, installation and maintenance instructions in this manual. The trouble free and safe operation of
this system requires safe transportation, professional storage, installation, operation and maintenance. Furthermore, all local
safety requirements have to be considered.
This system may not be used in the vicinity of combustible gases as parts of the system may cause a risk of explosion.
The device may only be put into operation if the enclosed instructions have been fully understood.
This manual is also available in other languages on request
To Next Page
Loading...
