3DFNDJH&RQWHQWV
1427950 TensMed 931
6WDQGDUG$FFHVVRULHV
The following accessories are included with your TensMed 931:
3444001 Electrode cable 2mm, 2 pc in conformity with FDA CFR 898
3444058 Self adhesive electrode 50x90 mm, 8 pc.
1427754 User manual TensMed 931
Alkaline AA 1,5 Volts (LR6) Batteries
Carry Pouch
2SWLRQDO$FFHVVRULHV
3444056 Self adhesive electrodes, size 32mm Ø, 1 pack = 10 sheets of 4 pc
3444135 Self adhesive electrodes, size 50mm Ø, 1 pack = 10 sheets of 4 pc
3444143 Self adhesive electrodes, size 70mm Ø, 1 pack = 10 sheets of 4 pc
3444057 Self adhesive electrodes, size 50x50mm, 1 pack = 10 sheets of 4 pc
3444058 Self adhesive electrodes, size 50x90mm, 1 pack = 10 sheets of 4 pc
3444146 Self adhesive electrodes with double lead, size 50x100mm, 1 pack = 10 sheets of 2 pc
,QVWDOODWLRQ
,QVHUW%DWWHULHV:
Insert two batteries. (A diagram inside the battery compartment shows how to insert the batteries
correctly.)
To check if the batteries have been correctly fitted, press the ON/OFF button once and the LCD display
will start up and the LED Lights will come on. Press the ON/OFF button again to switch the unit off.
Use only AA Alkaline 1.5 volt batteries (LR6).
Do not mix old and new batteries.
The battery contains material that is noxious to environment. You should attend the local regulations
when disposing the battery.
$WWDFK/HDGV:
Unravel leads and insert the plug(s) into either socket in the end of the unit. If using only one lead use L1
(as marked on the unit next to the socket).
$WWDFK(OHFWURGHVWROHDGV:
Remove electrodes from the bag and connect to the leads.
Simply push the plug on the electrode pigtail into the socket on the lead.
$SSOLFDWLRQRI(OHFWURGHV
&$87,21
• Connection of accessories other than the ones specified by the manufacturer can adversely
affect the safety of the patient and correct functioning of the equipment, and is therefore not
permitted.
127(
• The description below applies to electrotherapy applications in general. The electrolytic effects
mentioned do not apply to the Tensmed 931 as this device only generates fully balanced TENS
currents, that do not contain a DC component.
To Next Page
Loading...
Need help?
General
