Need help?Do you have a question about the enraf 854 ATG Series and is the answer not in the manual?
General| Brand | enraf |
|---|---|
| Model | 854 ATG Series |
| Category | Measuring Instruments |
| Language | English |
Explains the working principle based on buoyancy variations detected by a force transducer.
Lists optional boards and features like density measurement and alarm relays.
Describes capabilities for central monitoring via tank inventory systems.
Details certifications for explosion proofing and legal use.
Covers explosion proofing, environmental conditions, and housing features for safe operation.
Emphasizes required PPE, safe practices, and handling precautions in hazardous areas.
Explains the meaning of Warnings, Cautions, and Notes used in the manual.
Lists essential pre-commissioning checks for mechanical and electrical installation.
Step-by-step guide for installing the drum and displacer components.
Details how to program the gauge using the PET or Ensite tool, covering items and protection levels.
Describes procedures for calibrating the level measurement using different reference methods.
Explains the LCD display, its initialization, and programmable display formats.
Procedure to test and ensure consistent measurement readings.
Procedure to lock the displacer position for specific tests or maintenance.
Explains commands to stop or control displacer movement during operation.
Command to cancel previously issued operational commands.
Details how to measure product/water interfaces using different interface settings.
Describes the dip mode function for measuring at a specific height above the product surface.
Procedures to verify the accuracy of the level calibration against reference points.
Summary of data items, error codes, and operational commands for system interaction.
Outlines tests and checks to maintain instrument performance and identify issues.
Instructions on opening, closing, and maintaining waterproof seals of instrument covers.
Detailed description and maintenance of the drum compartment, including bearings.
Description of the electronic components and sub-assemblies, and precautions for handling.
Procedure for calibrating the force transducer using test weights.
Steps to synchronize the internal reference encoder after software or hardware changes.
Addresses issues with displacer movement, including manual control and potential causes.
Lists common XPU error codes and provides solutions for communication processor unit issues.
Lists common SPU error codes and provides solutions for servo processor unit issues.
Explains how to interpret status bytes for alarms, modes, and general status from the SPU.
To Next Page