Enseo HD2000 - User Manual

To Next Page

TA-8830+TA8300 Installation Manual

Last Revised: 3/26/12

Enseo Set Top Box (with ANY TV)

1 |

Ensure the DIP Switch Settings on ASM are in the appropriate positions according to the

installation choices below.

2 | Connect the cables between the MediaHub SL, ASM and TV and STB according to schematic

shown for your installation choice.

3 |

Plug the power supply into a wall power socket using the correct plug for your country.

4 | Power ON the TV and

conﬁgure the TV settings according to the

model-speciﬁc requirements below.

5| After all menu settings and AV connections are done, power cycle the TV to lock

in settings.

For Enseo HD3000 STB firmware v.2.12.04+ / HD2000 STB firmware v.2.10.29.17+

Follow the cable connection diagram below.

ASM DIP Mode: UP-DWN-UP-DWN

Conﬁgure Enseo STB: Press <Channel Up>, <Right Arrow>, <Left Arrow>, <MUTE>

to enter set-up screen. Go to Control Options and AUX panel. Set BAUD Rate to

115200.

Conﬁgure TV Menu Settings according to the TV make/model listed.

Special Notes:

The ASM Installation Kit contains an RS232

3.5mm control cable. Use this cable for the

Control connection to the Enseo STB.

For Enseo HD2000, use the RS232 Male control

cable included in the ASM installation kit.

If your hospitality TV has a built-in LodgeNet

terminal (internal terminal card), plug the

Game/Data cable into the TV’s DATA port.

The Enseo Control port does not draw any power

for the ASM. Therefore, a power connection is

required for the ASM’s USB Power In. The TV’s

USB port can supply power to the ASM, even if it

is labeled “Service Only.”

Be sure the ASM DIP Switches are set to the

appropriate positions:

Need help?

Do you have a question about the Enseo HD2000 and is the answer not in the manual?

Summary

Enseo Set Top Box Installation Overview

General Installation Steps

Steps for installing the Enseo Set Top Box, including DIP switch settings and cable connections.

HD3000;HD2000 STB Firmware Configuration

Configuration for specific firmware versions, including DIP mode and TV menu settings.

TV Configuration for Enseo Integration

Panasonic TV Configuration

Specific settings for Panasonic TVs to integrate with Enseo HD2000/3000.

LG TV Configuration

Instructions for LG TVs to enable Enseo Mode after inactivity.

Philips and Sharp TV Configuration

Notes that no specific TV configuration is needed for Philips and Sharp TVs.

Samsung TV Configuration

Detailed menu settings for Samsung TVs for Enseo integration.