Why Entre Matic Ditec TOP903H Garage Door Opener remote control doesn't work?
If the Entre Matic Garage Door Opener remote control isn't working, the batteries might be flat, or the LED isn't illuminated. Replace the batteries to solve this issue.
What to do if Entre Matic Ditec TOP903H Garage Door Opener automation doesn't work?
If the Entre Matic Garage Door Opener automation isn't working, the issue might be due to no supply voltage, incorrect voltage, or a faulty fuse. Replace the fuse to resolve the problem.
What to do if Entre Matic Ditec TOP903H Garage Door Opener automation stops during its stroke?
If your Entre Matic Garage Door Opener automation stops during its stroke, ensure the door moves smoothly and the safety device works properly. Perform a reset and repeat the learning procedure.
What to do if Entre Matic Garage Door Opener automation doesn't close?
If the Entre Matic Garage Door Opener automation doesn't close, it could be a safety command that has been activated or is faulty, or an alarm. Check the safety devices. If the problem persists, contact Technical Service.
What to do if Entre Matic Ditec TOP903H automation doesn't open?
If the Entre Matic Garage Door Opener automation doesn't open, the STOP command may be activated or faulty, or there may be an alarm. Check the STOP command. If the problem persists, contact Technical Service.
Why Entre Matic Ditec TOP903H Garage Door Opener courtesy light flashes at regular intervals?
The courtesy light on your Entre Matic Garage Door Opener flashes at regular intervals because the door has detected an obstacle. Check that the door moves smoothly and remove any obstructions.
What to do if Entre Matic Ditec TOP903H safety devices are not working?
If the safety devices on your Entre Matic Garage Door Opener are not working, it might be due to an incorrect setting of the door or safety device. Perform a reset and repeat the learning procedure. If the problem persists, contact Technical Service.
Why Entre Matic Ditec TOP903H automation closes the door slowly while the courtesy light is flashing?
When the Entre Matic Garage Door Opener automation closes the door slowly (soft start) while the courtesy light is flashing, the automation is performing the self-learning procedure. Wait until the procedure is completed. If the problem persists, contact Technical Service.
How to fix faulty Entre Matic Ditec TOP903H Garage Door Opener automation?
If you have faulty Entre Matic Garage Door Opener automation, the carriage release may not be correctly coupled, the toothed belt may not be correctly tensioned, or the door could be blocked. Check the release, belt, or door movement.
Why Entre Matic Ditec TOP903H courtesy light flashes 4 times?
If the courtesy light on your Entre Matic Garage Door Opener flashes 4 times, the door has not acquired the stroke. Perform the learning procedure as explained in chapter 15 or 21.
Essential safety information for users, covering proper use, hazards, and supervision.
Installer obligations and requirements under the Machinery Directive for safe installation.
Explanation of input terminals for commands like Step-by-Step, Opening, and Stop.
Programming remote controls for TOP903H using the unit's keypad.
Guidance on connecting external devices for the TOP903H model.
Information on self-diagnosis, error codes, and system status messages.
General| Manufacturer | Entre Matic |
|---|---|
| Model | Ditec TOP903H |
| Type | Garage Door Opener |
| Voltage | 230V AC |
| Protection Class | IP20 |
| Motor Type | DC |
| Control | Remote Control |
| Safety Features | Obstacle Detection |
| Installation | Ceiling mounted |
To Next Page
