14
Installation
PEDESTAL INSTALLATION - FREESTANDING:
The freestanding model comes with a pedestal
that has to be attached prior to installation:
• Remove the pedestal from the box
• Remove the unit from the box
• Place the unit on its back on the pallet.
• Back the four (4) screws in the base off three (3)
to four (4) full turns.
• Align the keyholes in the pedestal with the
screws, lock into place.
• Secure the two (2) pieces by tightening the four
(4) screws from the inside of the pedestal.
PEDESTAL INSTALLATION - FIREPLACE INSERT:
The pedestal for the fireplace insert is packaged in the hopper of the appliance. Secure the leveling (Z-
style) bracket onto the back two (2) pedestal mounting screws with the inserted nuts facing up. Insert
leveling legs into the nuts on the Z bracket if necessary.
Place the front portion of the pedestal into the front pedestal screws; there are two slots in the pedestal
that fit over these screws. Finish securing the pedestal using the four (4) T-20 Torx screws provided. This
will cover and seal the ash pan hole in the bottom of the firebox inside the appliance.
Figure 11: Freestanding Pedestal.
Figure 12: Fireplace Insert Pedestal and Leveling Legs.
To Next Page
Loading...
