What to do if the Enviro Water Dispenser Brine Tank has too much water?
If your Enviro Water Dispenser's Brine Tank has too much water or isn't filling properly, check and tighten all fittings on the Brine Tank and Electronic Head. This ensures that air isn't getting into the Brine Tank Hose, which can cause these issues.
Why is my Enviro UNITED WATER FILTERS AF24 Water Dispenser regenerating but not using salt?
If your Enviro Water Dispenser is regenerating but not using any salt, the salt may have bridged. This means too much salt has been added to the tank, forming a solid block. To fix this, shake the Brine tank until the block of salt breaks apart.
How to fix a leaking Enviro Water Dispenser at the top of the tank?
If you notice water leaking at the top of the tank around the head of your Enviro Water Dispenser, try tightening the head. Turn the head to tighten it, but be careful not to overtighten; just turn it snug. The tank head is pre-installed hand-tight.
What to do if Enviro UNITED WATER FILTERS AF24 tank leans?
If the tank of your Enviro Water Dispenser leans to one side or isn't level, lift the tank straight up about 6 inches and tap it on the ground until the tank stands vertically. The bottom of the tank is round, and the boot allows the tank to stand upright.
General| Brand | Enviro |
|---|---|
| Model | UNITED WATER FILTERS AF24 |
| Category | Water Dispenser |
| Language | English |
To Next Page
