ENVIRORIDES G2 PRO 2022 - eScooter Parameters and Malfunctions; eScooter Parameter Settings Guide; eScooter Malfunction Code Explanations

Parameter & Malfunction
3.1) Press and hold the mode button to access the eScooters
parameter settings. (DNA: Do Not Adjust*)
▪ P01: 10 (Wheel Diameter) DNA*
▪ P02: MPH or KM/PH
▪ P03: 00 (Speed Setting) DNA*
▪ P04: 48V (Battery Voltage) DNA*
▪ P05: 1 or 0 (Kick Start)
▪ P06: 1 or 0 (Electric Assist Braking Strength)
▪ P07: 1 or 0 (Cruise Control)
3.2) eScooter malfunction codes.
E3
Controller Unit & Motor Connection Error
E4
Low Voltage Protection
E5
Brake Lever Failure
E6
Connection Error
E8
Controller Error
E9
Light Error
Error Code E3)
• This error code will highlight when the G2 Pro Controller
Unit and Motor Connection has incurred a fault. If this
error code is activated, please see possible faults below.
o Loose Controller Unit and Motor Cable Connection
o Damaged Controller Unit
o Damaged Motor Cable