EO Basic Installation & User Guide V1.0
08 October 2019
10) An additional screw is provided should you need another earth
11) Replace the locking plate and screws to secure the unit. Power up the unit and test
Congratulations. Another EO Basic has been successfully installed!
2.2 Important Installation Information
Characteristics of power supply input
Permanently connected to 230V AC supply
Characteristics of power supply
output
Supplies 230V AC to the vehicle
Normal environmental conditions
Can be installed indoors or outdoors
Can be installed with no access restrictions
Stationary equipment intended for surface or post
mounting
Protection against electric shock
Mode 3 charging equipment. Note - Adaptors and
conversion adaptors sets are not allowed to be used with
the equipment. Cord extension sets are not allowed to be
used.
Ventilation during supply of energy
Does not support ventilation during charging
The installer must select the RCD and earthing configuration in accordance with local regulation &
best practice.
Where the EO Basic includes DC leakage protection (DCL) a Type A RCD can be fitted at the supply.
Otherwise a Type B RCD or equivalent should be used. EO recommend a 20A supply rated supply
circuit for a 16A charging station and 40A supply for on 32A charging station.
To Next Page
Loading...
