Fuel, 2-stroke Oil and Fuel Mix
Use fuel with min. 95 ROZ (unleaded or leaded) or higher only.
Recommended 2-stroke oil quality is either half synthetic or full synthetic with the following
specifications; API-TC (TSC-3); JASO FC or JASO FD
fuel mix
run-in procedure, first 3 hours operation approx. 3% / 1:33
regular operation 2.5% / 1:40
Please note! - every engine has been test run and carburetor settings have been pre-
adjusted properly prior delivery.
Starting the Engine
The carburetor is pre-adjusted right and the setting should work in general as it comes.
Pump up fuel from tank to carburetor whilst same time you should press the membrane
with your finger (see picture) to allow sufficient fuel flow into the carburetor's float chamber.
Important note! - never press the membrane with to much force.
Important note! - do not over-float the carburetor as in consequence the engine gets
floated and then it will be very difficult to start it.
As a next step close/activate the choke (see picture). No throttle at all. Pull starter rope as
many times as necessary until the engine fires the first time. As the next step open the
choke again. Now operate the throttle about 20% and pull again starter rope as many
times as necessary until the engine starts running, keep it running by operating the throttle
accordingly.
press membrane
choke lever
open position closed/activated
To Next Page
Loading...