EasyManua.ls Logo

EOS M3 - Page 14

EOS M3
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Service address:
EOS-WERKE Günther GmbH
Adolf Weiß Straße 43
D-35759 Driedorf
Germany
Tel: +49 (0)2775 82-240
Fax: +49 (0)2775 82-455
e-mail: servicecenter@eos-werke.de
Internet: www.eos-werke.de
Instructions
Leakage current on sauna heaters
For the installation of sauna heaters, please pay
attention to the DIN VDE 0100 part 703 !
This norme states in the latest issue valid since June
1992 under modifications paragraph (f); quote:
The demand for protection against leakage current for
equipment of protection class I alternatively to protective
low voltage has been dropped.
The EN 60335-1 DIN VDE 0700 part 1 of January 2001
states the following in paragraph 13; quote:
The leakage current may not exceed the following
values during operation:
- for stationary heaters of protection class I
0,75 mA; or 0,75 mA each kW input of the
appliance, depending on the higher value,
at a maximum value of 5 mA.
If the appliance is equipped with a protective device
for leakage current (ELCB), please pay attention to the
fact that no other electrical units will be protected by
this ELCB.
Under current manufacturing methods, it is not yet
possible to produce tubular heating elements for sauna
heaters which do not attract moisture on each end
from the surrounding air.
Therefore, should the ELCB be triggered during start-
up, the electrical installation must be checked.
It is also possible that moisture from the surrounding
air has been concentrated in the magnesium-oxide
filling in the heating elements during transport or
storage and is now causing the ELCB to be triggered.
In this case, the oven must be heated up under
supervision of an expert, during which the PE conductor
is not connected. After about 10 minutes, when
moisture has evaporated from the heating elements ,
the oven must be reconnected to the PE conductor!
If the sauna heater is not in use for a significant period
of time, we recommend running it every 6 weeks, so
as to avoid moisture concentrating in the heating
elements.
Installation of the sauna heater and control unit may
be undertaken only by an authorized electrician.
Without documentation of such installation, a warranty
is fundamentally invalid.
$
Guarantee
The guarantee is taken over according to the legal regulations
at present.
Manufacturers warrenty
- The period of warrenty starts from the date of purchase
and lasts up to 2years for commercial use and 3 years for
private use.
- Always include the completed warrenty certificate when
returning equipment.
- The warrenty expires for appliances which have been
modified without manufacturers explicit agreement.
- Damages caused by incorrect operation or handling
through non-authorized persons are not covered under
the terms of warranty.
- In the event of a claim, please indicate the serial number
as well as the article code number and type name with
expressive description of the fault.
- This warrenty covers damaged parts but no defects due
to wear and tear.
In case of complaint please return the equipment in its original
packaging or other suitable packaging (caution: danger of
transport damage) to our service department. Always include
the completed warrenty certificate when returning equipment.
Possible shipping costs arising from the transport to and from
point of repair cannot be borne by us.
Outside of Germany please contact your specialist dealer in
case of warranty claims. Direct warranty processing with our
service department is in this case not possible.
Outside of Germany please contact your specialist dealer in
case of warranty claims. Direct warranty processing with our
service department is in this case not possible.
Equipment start-up date:
Stamp and signature of the authorized electrician:
Attention!
Dear customer,
according to the valid regulations, the electrical
connection of the sauna heater and the control box
has to be carried out through the specialist of an
authorized electric shop.
We would like to mention to the fact that in case of a
warrenty claim, you are kindly requested to present a
copy of the invoice of the executive electric shop.

Other manuals for EOS M3