Need help?Do you have a question about the EOS M3 and is the answer not in the manual?
General| Brand | EOS |
|---|---|
| Model | M3 |
| Category | Electric Heater |
| Language | English |
Specifies that the sauna heater is exclusively for heating sauna cabins with an appropriate control unit.
Provides general information about checking unit condition, aligning cabin components, and sauna climate principles.
Details requirements for air intake and vent openings placement and dimensions for optimal sauna operation.
Specifies the use of designated control units and sensor placement for heater operation.
Guidelines for installing cabin lighting, ensuring compliance with specific standards and wattage limits.
Mandates that only certified electricians perform electrical connections to the mains.
Specifies requirements for electrical installation lines inside the cabin, including temperature suitability and protection.
Details required vertical and horizontal clearances for sauna heater installation relative to ceiling, walls, and floor.
Instructions for securing upright heaters with anti-tipping elements for safe installation.
Crucial warning to only pour infusion water on sauna rocks and never elsewhere to prevent damage or hazards.
Guidance on ensuring external glass surfaces do not exceed 76°C, with potential need for protective features.
Safety requirement to conceal power cables within sauna cabin walls or protective ducts.
Details warranty requirement for documented proof of installation by a certified electrician.
Provides key technical specifications including power intake, cabin size, and dimensions.
Specifies the minimum required inside height of the sauna cabin and clearance dimensions for the heater.
Instructions on mounting the rear wall panel to the cabin wall using provided screws, referencing dimensional diagrams.
Warning regarding mounting holes: cams must not be in a groove to ensure proper contact with the cabin wall.
Details on mounting the sensor bracket to the cabin wall, specifying position relative to the heater exhaust outlet.
Guidance on protecting capillary tubes against contact if they lack an insulating mantle.
Step-by-step guide to exchanging front and rear panels for left-side installation, involving screw removal and panel repositioning.
Crucial instruction to never operate the heater without sauna stones in place, checking for foreign objects.
Explains the safety temperature limiter (STL) that automatically shuts off the heater during overheating.
Presents a schematic diagram illustrating the electrical connections for a sauna system.
Guidance on placing sauna stones loosely to allow for proper air circulation and heat distribution.
Emphasizes keeping air supply vents and reflection surfaces clean from dust and fuzz for optimal convection.
Recommends using only original manufacturer replacement parts for maintenance and repairs.
Advises checking for clothes, cleansers, or objects on the heater before use after a period of non-operation.
Highlights adherence to DIN VDE 0100 Part 703 for sauna heater electrical installation requirements.
Specifies maximum permissible leakage current values for stationary heaters as per EN 60335-1.
Procedure for heating the oven without PE conductor to evaporate moisture in heating elements after storage.
States that warranty is void without documented proof of installation by an authorized electrician.
Provides contact details for EOS Saunatechnik GmbH, including phone, fax, email, and website.
Advises providing model, item, and serial numbers for quick and competent customer service.
Defines the applicability of service terms and conditions for service operations and legal relationships.
Lists costs the ordering party bears for service operations, including disassembly, assembly, and transport.
Outlines warranty conditions, including proof of purchase, period, and voiding factors like modifications or improper use.
Specifies that wear parts, such as heating elements and stones, are excluded from warranty coverage.
To Next Page
