21
EN
Commissioning and initial operati-
on
The sauna heater must never be operated
with an empty stone grate. Ensure prior to
initial operation that no objects have been
left lying on the sauna heater.
This knob is used to set the heating
period up to a maximum of 4 hours.
Turn the knob to the desired heating time and
the heater begins to heat up.
This knob is used to set the desired
sauna temperature. Please remember
that temperature is controlled near the tem-
perature sensors and that temperatures will
vary within the sauna cabin. Temperature is
controlled with a range between 30° C and 110°
C. Ordinarily, sauna bathing temperature in the
area around the upper recliner bench will be
between 80° C and 90° C.
Safety temperature limiter
The sauna heating unit is equipped with a
safety temperature limiter (STL), which auto-
matically shuts the heater o when the sauna
overheats. In this case, the system must be
checked by a specialist. The STL must then be
reset before the heater can be operated again.
Sample wiring diagram for a sauna system
Important! The ground lead (N) must
always be connected
Heating coil
Heating coil
Thermostat
Temperature
limiter
Timer
Main power
grid
Main power
connection
To Next Page
Loading...