23
REMOVING THE COMPRESSOR LOCK
To prevent the compressor and the pipes from moving during transportation and installation, a bracket is used to lock the
compressor. This bracket must be removed before starting up the compressor.
Under the unit, on the right side, by the red label, there are two wing nuts that must be completely unscrewed, and removed
to free the compressor. This must be done before powering up the unit.
Compressor lock wing nuts
NOTICE
DAMAGE TO UNIT
You must remove the compressor lock before turning the unit on.
Failure to do so can damage the unit and void the warranty.
To Next Page
Loading...
Need help?
General