EasyManua.ls Logo

EPIC CART E40L - Page 13

EPIC CART E40L
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION INFORMATION
Owner’s Manual
11
WARNING To reduce the possibility of severe injury or death resulting from improper vehicle operation,
the following warnings must be observed:
Refer to GENERAL SPECIFICATIONS for seating capacity.
Depressing accelerator pedal will release foot operated park brake and may cause inadvertent vehicle movement.
Turn the key to the ‘OFF’ position whenever the vehicle is parked.
To prevent inadvertent movement when the vehicle is to be left unattended, engage the park brake, move
direction selector to forward position, turn key to ‘OFF’ position and remove key.
Make sure that the direction selector is in correct position before attempting to start the vehicle.
Always bring the vehicle to a complete stop before shifting the direction selector.
Do not take vehicle out of ‘gear’ while in motion (coast).
Check the area behind the vehicle before operating in reverse.
All occupants must be seated. Keep entire body inside vehicle and hold on while vehicle is in motion.
The lifespan, the reliability of the work and the economic efficiency of the use of EPIC Lifted Cart, all depend to a
large extent on the running-in at the initial stage of use. The running-in mileage is 800 kilometers. If conditions
permit, it is best to extend it to 1500Km.
The new cart must go through a running-in before it is officially used. During the running-in period, it should run
at a lower speed. Generally, it cannot be fully loaded and absolutely cannot be operated with overload. The
purpose of running-in is to allow the parts and components to perform a stage of running-in, improve its surface
quality and matching accuracy, and avoid early wear and tear of the vehicle.
The following regulations shall be complied with during the integration period
Avoid fast starting, rapid growth and unnecessary tight braking.
During the running-in period, the vehicle speed must be strictly controlled within 20Km/h.
Frequently check whether the battery, electric control, and motor connection wires are loose due to heat.
Frequently check the temperature of the reducer, rear axle, wheel hub and brake drum. If there is overheating
(greater than 60°C), check and eliminate the fault.
When the running-in mileage reaches 500Km, check the tightness of the steering system, front
suspension and wheel nuts and tighten if necessary. After the running-in period, the user should replace the
lubricating oil and rear axle gear oil during the shifting period.
During the running-in period, the battery cannot be deeply discharged. After the running-in
period expires, the battery is not allowed to be over-discharged. Over-discharge will quickly
damage the battery.
If the vehicle mileage is less than 60% of the rated continuous mileage when the vehicle is used for the
first time, please stop using the vehicle and notify the company's after-sales department as soon as possible to
find out the reason. The vehicle is used for more than one month, and the company is no longer responsible for
the compensation of the entire battery pack. Within half a year, due to battery manufacturing quality problems,
the company promises quality warranty for damaged batteries.