Before using the epoc NXS Host for testing,
charge its battery as follows:
• Connect the epoc Reader power supply to
the power jack on the back of the Reader.
• Insert the epoc NXS Host into the epoc
Reader’s pivot slot as shown.
The initial charge will take up to ve hours.
• After the charge is complete, press and hold
the Power button to turn on the epoc Host.
2
Prior to use . . .
Note: Prior to using this device, check at the Siemens Healthineers Document Library
(siemens.com/document-library) if any applicable updates Host software and/or operating
system are available. Ensure that the device is running the latest version of Host software and/or
operating system.
Step 1: Charge the epoc NXS Host
Note: To wake up an epoc Host that is already powered on, briey press and release the Power
button.
Note: To suspend the epoc Host, press the Power button on the side of the device.
Note: To restart the epoc Host, press and hold the Power button for at least 10 seconds; the device
will then restart.
For facilities not using a data management system, skip Steps 2 and 3.
• Sign in as the Administrator.
At the Sign-In screen, scan or enter the word
“administrator” into the User ID and Password elds.
To scan, aim the Barcode Scanner at the barcode below
and press the Scan button.
To enter as text, use the soft keyboard.
Step 2: Connect to your Wi-Fi Network
Note: Please read Step 2 in its entirety before starting. It may be necessary to contact your facility’s
Information Technology department to obtain the proper Wi-Fi connection and security settings.
To Next Page
Loading...
Need help?
General