EasyManua.ls Logo

Epoke TKG12 - General; Thermal Hazard; Hazard Caused by Noise; Hazard Caused by Vibrations

Epoke TKG12
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
epoke
®
TK, TMK
GB-0612.2
2.0.3.4 Thermal hazard
Thermal Hazard - not applicable.
2.0.3.5 Hazard caused by noise
A noise measurement has not been carried out as the noi-
se pollution depends on the used vehicle.
2.0.3.6 Hazard caused by vibrations
Vibration measurement is omitted - not relevant.
2.0.3.7 Hazard caused by radiation
Radiation measurement is omitted - not relevant.
2.0.3.8 Hazard caused by materials and substances
Demounting (scrapping): Is to be carried out by a environ-
mental acknowledged scrap merchant.
2.1 Safety measures
2.1.1 General safety measures
All EPOKE spreaders and equipment can be
operated by one person. Spread is controlled
entirely from the driver’s cab.
Instruction - The owner of the carrying vehicle undertakes
to ensure that the spreader is used only by people who:
know the basic safety regulations and are thoroughly
familiar with the operation of the spreader
have read and understood the section on safety and the
warnings in the technical documentation.
Instruction - Everyone who is authorised to work with the
spreader undertakes:
to familiarise themselves with the basic safety regulations.
to read and understand the section on safety and the
warnings in the technical documentation.
Instruction - only trained and instructed personnel are
permitted to work with the spreader:
The authorisation of the personnel for starting, operating,
maintenance and repair must be clearly defined.
Personnel in training may only work with the spreader
under the supervision of an experienced person.
Instruction - The spreader is designed with the safety
regulations in mind. Even so, the life of the driver may be
at risk while the machine is in use.
The spreader may only be used for its intended purpose
and in the proper condition as regards safety equipment.
Out of consideration for safety, the following is to be
observed:
Before operation the operator is to check whether devices
for control, safety and protection are correctly fitted and ok.
If defects are noted on safety devices or when other de-
fects are noted which have influence on the safe
operation of the machine, there cannot be any operation
until these defects have been repaired.
Correction of flaws, maintenance and repairs are only to
be carried out, when the machine is not in operation.
After maintenance or repairs, the safety devices are to be
correctly placed.
2.1.2 Reference to permitted total weight
TKG12, TKEB12
Permitted total weight . . . . . . . . . . . . . . . . . . . . .2000 kg
Permitted axle load . . . . . . . . . . . . . . . . . . . . . . .1500 kg
Supporting load on draweye . . . . . . . . . . . . . . . . .640 kg
Net weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .640 kg
TK12E, TK12E275
Permitted total weight . . . . . . . . . . . . . . . . . . . . .2000 kg
Permitted axle load . . . . . . . . . . . . . . . . . . . . . . .1500 kg
Supporting load on draweye . . . . . . . . . . . . . . . . .640 kg
Net weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .600 kg
TKB9-280
Permitted total weight . . . . . . . . . . . . . . . . . . . . .2000 kg
Permitted axle load . . . . . . . . . . . . . . . . . . . . . . .1500 kg
Supporting load on draweye . . . . . . . . . . . . . . . . .640 kg
Net weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .710 kg
TKB12-280
Permitted total weight . . . . . . . . . . . . . . . . . . . . .2000 kg
Permitted axle load . . . . . . . . . . . . . . . . . . . . . . .1500 kg
Supporting load on draweye . . . . . . . . . . . . . . . . .640 kg
Net weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .710 kg
TMK10, TMK10-275
Permitted total weight . . . . . . . . . . . . . . . . . . . . .1500 kg
Permitted axle load . . . . . . . . . . . . . . . . . . . . . . .1300 kg
Supporting load on draweye . . . . . . . . . . . . . . . . .250 kg
Net weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .400 kg
TMK7, TMK7GT
Permitted total weight . . . . . . . . . . . . . . . . . . . . .1300 kg
Permitted axle load . . . . . . . . . . . . . . . . . . . . . . .1300 kg
Supporting load on draweye . . . . . . . . . . . . . . . . .250 kg
Net weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .340 kg

Table of Contents

Related product manuals