BIOS
Page 4-8
FSB Frequency
Enables you to set the CPU frontside bus speed. Enables you to subtle tuning FSB.
CPU Interface
Allows you to set CPU/FSB parameters for CPU most stable or overclocked.
Options: Optimal, Aggressive.
Memory Frequency
Enables you to select the memory frequency.
Options: By SPD, 50%, 60%, 66%, 75%, 80%, 85%, Sync, 120%, 125%, 133%,
150%, 166%, 200%.
Memory Timings
For setting DRAM Timing.
Options: Optimal, Aggressive, Expert.
T (RAS)
This item specifies the number of clock cycles needed after a bank active command
before a precharge can occur (sets the minimum RAS pulse width.).
Options: 1 ~ 15.
T (RCD)
This item sets the timing parameters for the system memory such as the CAS (Column
Address Strobe) and RAS (Row Address Strobe).
Options: 1 ~ 7.
T (RP)
This item refers to the number of cycles required to return data to its original
location to close the bank or the number of cycles required to page memory
before the next bank activate command can be issued.
Options: 1 ~ 7.
CAS Latency
Enables you to select the CAS latency time. The value is set at the factory depending
on the DRAM installed. Do not change the values in this field unless you change
specifications of the installed DRAM.
Options: 2.0, 2.5, 3.0.
To Next Page
Loading...
