19
3. Test mode
This mode is the same as Dusk to Dawn. But there is no 10 minutes
delay when controller recognizes the starting voltage. When below the
starting voltage, the controller will turn on the load, if higher, it will
turn off load. The test mode makes it easy to check the system
installation.
4. Manual mode
This mode is to turn ON and OFF the load by manual.
Load Work Mode Setting
Press the setting button for more than 5 seconds till the indicator
flashes. Press the button, the corresponding indicator 8H、4H、2H、1H
will be on according to the following table.
The setting is finished when the indicator stop flashing.
To Next Page
Loading...
