5.4 Device information
The product model, parameters and SN code of the controllers are displayed
below:
Operational tips: and buttons are respectively used to turn the
browse page upward and downward.
5.5 Test operation
Load switch test operation is conducted on the connection solar controller
to see if the load output is normal. The test operation does not affect the
working settings under actual load, which means that the solar controller will
exit from the test mode when exiting the operational interface of the test.
Operational tips: Enter the page and input correct password; use and
buttons to modify the On/Off status values, while use and buttons
respectively to confirm and cancel the test operation.
To Next Page
Loading...
