Epson 10020 - Page 39

3. Insert a blank 5 1/4-inch 360KB diskette in drive B (the
bottom drive) and turn the latch down to secure the
diskette.
4. Type the following and press Enter.
DISKCOPY A: B:
The screen displays these prompts:
Insert SOURCE diskette in drive A:
Insert TARGET diskette in drive B:
Press any key when ready ...
5. Drive A (the top drive) already contains a diskette you
want to copy (the source diskette) and drive B contains the
blank target diskette, so just press any key. The
DISKCOPY program begins the copy process.
If the diskette in drive B is not formatted, the DISKCOPY
program formats it. (Formatting prepares a diskette to store
data and is described in Chapter 3.) Then the program
copies the contents of the diskette in drive A to the
formatted diskette in drive B. When the copy is complete,
you see this prompt:
Copy another diskette (Y/N)?
6. Press Y so you can make a copy of the Operating 2 diskette.
Again, you see these prompts:
Insert SOURCE diskette in drive A:
Insert TARGET diskette in drive B:
Press any key when ready . . .
7. Remove the original Operating 1 diskette from drive A and
the copy from drive B. Insert the Operating 2 diskette in
drive A and another blank diskette in drive B. Then follow
the instructions above and the prompts on the screen to
make a copy of this diskette.
1-22 Setting Up Your System