8.
Repeat the procedure for the Startup diskette and the
Reference diskette.
9.
When you finish copying the last system diskette and the
Copy another diskette (Y/N)? prompt
appears, press N to return to the MS-DOS command
prompt.
Copying Diskettes on the Apex l00\20
1.
The
C>
prompt should be on the screen; if it is not, type
C
: and press
Enter.
2.
Type the following and press
Enter:
DISKCOPY A: A:
The screen displays these messages:
Insert SOURCE diskette in drive A:
Press any key when ready . . .
3.
insert the Startup diskette in drive A (the diskette drive),
as shown below, with the label facing up and the read/write
slot leading into the drive.
Setting Up Your System
1-23
To Next Page
Loading...