6
Testing the printer
To test whether the printer is correctly installed, first turn it on.
Then print a test sheet by briefly pressing the button located
next to the parallel interface port at the back of the printer. The
test sheet contains information about the printer, including the
current settings.
7
Connecting the printer to the
computer
1.
Turn off the printer and make sure the computer is off.
2.
Connect a shielded parallel interface cable to the connector
on the back of the printer. Fasten the connector with the
two wire clips.
3.
Connect the other end of the interface cable to the back of
your computer. Tighten the screws on both sides of the
connector.
12 Setup
To Next Page
Loading...
