Epson 2200 - Stylus Photo Color Inkjet Printer - Page 3

Page 2 of 2
Updating the firmware:
1.) Configure the Mac and the print server for TCP/IP.
2.) Download/copy the “
WLEP399.bin”
firmware file from the epson10651.sea.hqx to
the Apple Desktop.
3.) Navigate to
Macintosh HD>Applications>Utilities>Terminal
4.) At the terminal screen do the following:
1. Type
cd desktop
then press the RETURN key
2. Type tftp <
ipaddress*
of the print server> then press the RETURN key
3. At the tftp> prompt, type
binary
then press the RETURN key
4. At the tftp> prompt, type
put <WLEP399.bin**
> then press the RETURN key
*Where
ipaddress
is the IP address of the Wireless print server. Examples
135.79.2.468 or 10.0.1.3
**Where
WLEP399.bin
is the filename of the 3.99 firmware update.
5. You will get a message on the screen, at the
TFTP>
prompt, that a number of bytes
were sent. This means the update is complete.
5.) Next, go to the print server and perform a reset, then launch WP-Admin again to setup the
print server. At WP-Admin in the search screen, click on
CLEAR
, then click on
START
for
the print server to reappear. Finish the print server configuration, then Quit WP-ADMIN.
Search for the printer:
Once the update is complete, open the Print Center.
Select ADD Printer and choose Epson AppleTalk. This will allow you to select the Stylus
Photo 2200 printer.