Message Broadcasting 1
Message Broadcasting
Message Broadcasting is a plug-in for EMP Monitor. Administrators
can use the plug-in to send messages or announcements to one or
more projectors or all the projectors on the network. You can send
messages manually, or use the Timer function in EMP Monitor to
have messages sent automatically.
You can use Message Broadcasting to send images in JPEG format.
The maximum resolution for an image is 1920 × 1200 pixels.
Getting Started
Before you install the Message Broadcasting plug-in, make sure EMP
Monitor (version 4.30 or later) is installed, and your projectors are
registered in EMP Monitor. Make sure your projectors support
Message Broadcasting; check epson.com/support if necessary.
Follow the instructions on the Epson website for downloading and
installing.
You need to use a networked Windows computer running Windows
®
Vista
®
, XP, or 2000 Professional to install the plug-in.
If any of the projectors you select are switched off, they will power on
automatically when you begin Message Broadcasting. For network
communication, make sure the
Standby Mode setting in the
projectors’ Extended menu is set to
Communication On.
To Next Page
Need help?
General