Message Broadcasting 9
Solving Problems
If messages fail to display on the selected projectors, check the
following:
■ If the message does not appear on any of the projectors, check the
firewall settings on the computer running EMP Monitor. Make
sure EMP Monitor is selected as an exception.
■ If an individual projector fails to display the message, make sure
the
Standby Mode setting in the projector’s Extended menu is
set to
Communication On.
■ Try restarting the projector. If a projector user or presenter has
pressed the
Esc button to stop the message broadcast, the
projector will not receive messages until it is restarted.
© 2009 Epson America, Inc. 4/09 CPD-27543
To Previous Page
Loading...
Need help?
General