Power on the printer and press the ink
button. When the carriage has moved to
the cartridge removal position unplug the
mains cable from the printer.
This allows the carriage to be moved
manually.
Move the carriage to the left, insert the
screwdriver into the hole and raise the
screwdriver to lever off the hinge. Remove
the cartridge lid.
Remove any cartridges from the machine.
Remove the centre bung from the rubber
seal.
BE CAREFUL NOT TO DAMAGE THE SEALS
WHEN REMOVING THE CENTRE BUNG
Repeat this for all colours, then place to
the right of the printer as shown.
NEVER PLACE THE BOTTLES HIGHER THAN
THE LEVEL OF THE PRINT HEAD
To Next Page
Loading...
