Remove the backing tape from the sticky
pads on the tube support bracket.
Position the bracket around the printer
button housing, ensuring the plastic tab
fits into the slot.
ENSURE THE SURFACE OF THE PRINTER
HOUSING IS CLEAN AND DRY
Place the tubes into the tube support
bracket and move the carriage all the way
to the left of the printer, remove any slack
by adjusting the tubes while in the support
bracket.
Remove the backing tape from the small
support bracket and fit as shown.
ENSURE THE SURFACE OF THE PRINTER
HOUSING IS CLEAN AND DRY
Attach the printer lid support brackets as
shown. You can now close the lid.
To Next Page
Loading...
