1. Turn off the product.
2. Unplug the power cable.
3. Disconnect any connected cables.
4. Remove any paper from the product.
5. Open the printer cover and check that the ink cartridge holder is all the way to the right (the home
position). If necessary, plug in and turn on the product, then turn it off again using the power
button after the ink cartridge holder is in the home position.
6. Fasten the ink cartridge holder to the case using tape. Leave the ink cartridges installed to avoid
damaging the product.
Note: Some tape may be difficult to remove if left in place for a long time. Remove the tape
immediately after transporting the product.
108
To Next Page
Loading...
