4
• When installing the Touch Unit within the frame of the whiteboard, secure the Touch Unit with magnets
or screws.
Make sure there are no obstacles, such as cables, or protruding objects such as whiteboard trays, pen
holders, or thick frames in the shaded areas in the following figure. The Touch Unit will not operate
correctly if anything is obstructing the infrared signal.
• When installing the touch unit above the frame of a whiteboard, use the included Touch Unit Bracket.
• If the distance from the wall to the surface of the whiteboard is greater than 2 inches (51 mm), you
must install the Touch Unit on the whiteboard.
• If the frame of the whiteboard extends more than 0.1 inch (3 mm) away from the board surface, you
must install the Touch Unit on the whiteboard or screen.
To Next Page
Loading...
