Do you have a question about the Epson BrightLink 685Wi and is the answer not in the manual?
Matrix size | 0.59 \ |
---|---|
Number of colors | 1.073 billion colors |
Native aspect ratio | 16:10 |
Projection distance | - m |
Projection technology | 3LCD |
Contrast ratio (dynamic) | 14000:1 |
Contrast ratio (typical) | 300:1 |
Screen size compatibility | 60 - 100 \ |
Projection distance (tele) | 0 - 0.6 m |
Projection distance (wide) | 0 - 0.4 m |
Projector native resolution | WXGA (1280x800) |
Vertical synchronization (max) | 0.12 kHz |
Vertical synchronization (min) | 0.1 kHz |
Keystone correction, horizontal | ±3 ° |
Projector brightness (economic mode) | 2900 ANSI lumens |
Focus | Manual |
Throw ratio | 0.28:1 |
Digital zoom | 1.35 x |
Focal length range | - mm |
Lamp power | 250 W |
Light source type | Lamp |
Service life of light source | 5000 h |
Service life of light source (economic mode) | 10000 h |
Full HD | No |
Analog signal format system | NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM |
Microphone in | Yes |
Composite video in | 1 |
HDMI ports quantity | 3 |
Serial interface type | RS-232C |
USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
Component video (YPbPr/YCbCr) in | 0 |
Wi-Fi | - |
Noise level | 35 dB |
Noise level (economic mode) | 29 dB |
RMS rated power | 16 W |
Placement | Wall |
Product type | Short throw projector |
Product color | Grey, White |
Market positioning | Short throw |
Cable lock slot type | Kensington |
Power source | AC |
AC input voltage | 220 - 240 V |
AC input frequency | 50 - 60 Hz |
Power consumption (standby) | 2.2 W |
Power consumption (typical) | 373 W |
Storage temperature (T-T) | -10 - 60 °C |
Operating temperature (T-T) | 5 - 35 °C |
Storage relative humidity (H-H) | 10 - 90 % |
Operating relative humidity (H-H) | 20 - 80 % |
Depth | 400 mm |
---|---|
Width | 367 mm |
Height | 149 mm |
Weight | 5900 g |
Connect the computer to the BrightLink projectors using video and USB cables.
Configure computer display settings to extend desktop across both projectors.
Enable the Multi-Projection feature on both projectors for DuoLink setup.
Assign unique IDs to projectors and remote for coordinated control.
Adjust projector images for brightness and color to minimize differences.
Calibrate the pen to coordinate its position with the cursor location.
Calibrate finger touch for interactive use, ensuring finger position matches cursor.