Note:
You can slide the left edge guide to the left in 1/10-inch increments to increase the left margin on your
printout.
5. Slide the paper printable side up between the edge guides until it meets resistance. The printer
loads the paper automatically.
Note:
When feeding paper, place your hand flat on the paper and push it to completely into the feed slot.
If the first line on your page appears too high or low, you can adjust its position using the Micro Adjust
function. See “Adjusting the top-of-form position” on page 56.
Loading paper in the rear sheet guide
Follow these steps to load paper in the rear sheet guide:
Note:
Make sure the sheet guide is in the upright position.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User’s Guide
Paper Handling 47
To Next Page
Loading...
Need help?
General