Epson C831 - Operation Completion and Maintenance; Final Setup and Printing Start; Blade Holder Management; Slitter Blade Replacement

STEP 7
Switch on the Slitter.
Slowly turn the speed knob. Run the
slitter until the labels reach the bottom
of the take-up core holder.
Remove the labels that have rewinded
onto the take-up core holder.
STEP 8
Attach the labels to the core using a
waste label or tape.
Switch on the slitter and slowly turn to
increase the speed.
Now you can start to print.
HOW TO ADD OR REMOVE A BLADE HOLDER
Keep out the iron slide bar unscrewing the
thumb screw.
1
Slide in or out the blade holder.
Relocate the slide iron bar in its position
and rescrew the thumb screw.
2
REPLACING SLITTER BLADES
Loosen the two screws holding the blade in
place.
Replace the blade.
Fix back the screw to holding the blade in
place.