REWINDER GUIDES ALIGNMENT
Metal glides adjustable to obtain rolls of
labels perfectly aligned.
ULTRASONIC SENSOR CALIBRATION
WARNING: Before proceeding with the ultrasonic sensor
calibration, turn “OFF” the module that needs to be calibrated
(laminating or matrix removing).
1. Take a paper clip and insert it into the little hole located next to the OFF-ON
switch and push it down for 5 seconds. The yellow led will light up.
2. Raise the tension arm. The yellow led will stay on.
3. Once again, insert the paper clip down into the hole for 5 seconds. The led will
light o.
Ultrasonic sensor calibration complete.
To Next Page
Loading...
