56
Chapter2 Setup
8
Place your hand on the paper to flatten it, and slide the movable edge guide against
the paper.
9
Insert the paper into the paper feed slot until paper feeding starts automatically.
Do not load backing paper that has no labels on it. The paper may not be detected and not be fed
automatically.
10
Rotate the spindle to remove looseness in the paper.
CAUTION
If the movable edge guide is not properly slided against the paper, print position may
become incorrect or a paper jam may occur. Make sure to follow the guidelines below.
• There should be no gap between the
guide and the paper edge.
• Do not slide the guide against the paper
too tightly.
To Next Page
Loading...
