Correcting keystone distortion in horizontal directions
Press the [ ][ ] buttons on the control panel.
a
You can set manual H/V-Keystone from the Configuration menu.
s Settings - Keystone - H/V-Keystone p.80
Correcting manually (Quick Corner)
This allows you to manually correct each of the four corners of the
projected image separately.
a
Press the [Menu] button while projecting.
s "Using the Configuration Menu" p.74
Using the remote control Using the control panel
b
Select Keystone from Settings.
c
Select Quick Corner, and then press the [Enter] button.
Adjusting Projected Images
37
To Next Page
Loading...
