The projector is provided with the following five indicators that indicate the operating status of the projector.
A
Power indicator
Indicates the projector's status.
B
Status indicator
Indicates the projector's status.
C
Lamp indicator
Indicates the projection lamps status.
D
Temp indicator
Indicates the internal temperature status. This is normally turned off.
E
Filter indicator
Indicates the air filter status. This is normally turned off.
The following indicator status are used during regular operation.
Indicator Projector's Sta-
tus
Explanation
Power Status Lamp Temp Filter
Blue - On Off Off Off Off
Standby condition
Power is being supplied to the projector. In this status, you can start projecting by pressing the [
] button
on the remote control or control panel.
(Sometimes, when the power cord is unplugged, the power indicator remains lit for a short period, but this
is not a fault.)
Network monitor‐
ing status
The projector is being monitored and controlled over a network (when Standby Mode is set to
Communication On).
If the power cord is disconnected and then reconnected in this status, the power indicator flashes blue.
Blue - On
Blue -
Flashing
Status
varies
Off Off
Warm-up status This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds
after the lamp turns on.
The [t] button is disabled during warm-up.
Reading the Indicators
166
To Next Page
Loading...
