Transport and Installation Handbook
8
Warning
You may need dedicated installation mounts to tilt and install the projector.
Contact a professional and prepare the mount.
•
Plan so that the mount does not fall.
•
Make sure the mount is strong enough to support the projector.
•
When attaching a mount to the projector, secure the mount with bolts using the handle
securing section (6 points) on the top or base of the projector.
Since special techniques are required to install the projector on a ceiling
(ceiling mount) or in a high location, make sure you contact a professional.
If installation work is not carried out correctly, the projector could fall down. This may result
in injury or accidents.
Note the following points when installing so that the projector's air intake
vent or air exhaust vent are not covered.
If either of the vents is covered, the internal temperature could rise and cause a fire.
•
Make sure you secure the following space around the projector.
500mm
500mm
500mm
•
When setting up multiple projectors, make sure there is a gap of at least 500 mm between the
projectors.
500mm
•
Make sure you secure the following space when installing with the air intake vent underneath.
•
A gap of at least 100 mm between the installation surface and the air intake vent.
•
A space of 800 x 350 mm around the entrance of the air intake vent.
100mm
800mm
350mm
To Next Page
Loading...
Need help?
General