Check Remedy
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to
Off from Remote Receiver in the Configuration menu.
s Settings - Remote Receiver p.70
Is the correct setting for the Remote Receiver selected? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.70
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
s "Replacing the remote control batteries" p.17
I want to change the language for messages and menus
Check Remedy
Change the Language setting. Adjust the Language setting from the Configuration menu.
s Extended - Language p.71
Image file names are not displayed correctly in Slideshow
Check Remedy
Is the file name too long? The file name can be up to 8 characters long. For file names longer than this, the middle of the name is
omitted to shorten the name to 8 characters.
Are there any 2-byte characters in the file name? Only alphanumeric characters and symbols can be used in file names. Any other characters are replaced with a
question mark (?).
Problem Solving
87
To Next Page
Loading...
Need help?
General
Weight and Dimensions
