19
About the LED Indicators
■
indicator status during normal operation
Orange
Standing by
Press to start projection.
Green
Warm-up in progress
is unavailable for about 30 seconds.
Green
Projection in progress
The projector is operating normally.
■
Indicator status during an error/warning
Red
Red
Red
Internal Error
Disconnect the power cable from the electrical
outlet, and contact your local dealer of the
nearest address provided in the Epson Projector
Contact List.
Red
Red
Fan Error
Sensor Error
Red
Red
High Temp Error
Wait for about ve
minutes, and then
disconnect the power
cable from the electrical
outlet.
Check the following two points.
•
If the projectors are installed next to a wall,
move it away from the wall.
•
Clean or replace the air lter.
Red
Orange
High Temp Warning
Red
Red
Lamp Error
Lamp Failure
Check the following three points.
•
Remove the lamp and check that it is not
cracked. If it is not cracked, reinstall the lamp
and turn on the projector. If it is cracked,
con
tact your local dealer or the nearest address
provided in the Epson Projector Contact List.
•
Check that the lamp and the lamp cover are
securely installed.
•
Clean the air lter.
Orange
Replace Lamp
Replace it with a new lamp as soon as possible.
The lamp may explode if you continue to use it in
this status.
Red
Red
Red
Auto Iris Error
Power Err.
Disconnect the power cable from the electrical
outlet, and request maintenance.
If the error continues to occur after checking the points above, disconnect the power cable from
the electrical outlet, and contact your local dealer or the nearest address provided in the Epson
Projector Contact List on the Document CD-ROM.
The LED indicators change according to the status of the commander and the receiver.
Lit Flashing O
To Previous Page
Loading...
